Explorer 16 Programming Tutorial 2. Upon completing this tutorial, you should be able to: It is not designed to be a USB bus power source. From the list of folders on the PC, locate the C: Explorer 16 Development Hardware 4. The Explorer 16 board has multiple LCD footprints and support options, although only one footprint is ever populated at one time. For more information on which pins of the bit devices are 5V tolerant, refer to the appropriate device data sheet.
|Date Added:||7 March 2018|
|File Size:||9.91 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The project is now ready to build. Reference information d51284 in this data sheet includes: Jumper J7 decides the terminus of the ICD 2 connector. Installing this firmware is described in Appendix B. This tells the environment where to find the library files. Observe the progress of the build.
The LCD is driven via the port pins. The Explorer 16 kit does not include a power ds15284. It is not designed to be a USB bus power source.
Explorer 16 Tutorial Programs 3.
Select the Help menu, and then Topics to open a list of available on-line help files. Allow it to do so.
Refer to Chapter 3. RD0 as four of the data lines, instead of RE7: To register, access the Microchip web site at www. Upon completing this tutorial, you should be able to: Explorer 16 Development Hardware 4.
To exit and continue to the next mode, press S4. To exit the display and continue to the next mode, press S4.
These are provided as pin PIMs on riser sockets, which can be quickly installed on pin header U1A and exchanged as needed. The progress of the update is displayed in the status bar of the programming software.
It is also used to demonstrate SPI bus operation. From the list of folders on the PC, locate the C: Explorer 16 Programming Tutorial 2. The board also has a matching male edge connection J9allowing it to be used as an expansion card itself.
Select the General tab. Setup mode starts with the tens digit of the hour in the time display.
From the Project menu, select Project Wizard. To do this, set the terminal emulator for baud, 8-bit data, 1 Stop bit and no parity check. The Explorer 16 board uses two dd51284 analog multiplexers to simplify the con- nections between itself and any daughter boards. The screen shots in the following sections show the PIC24 tutorial.
The settings that will most likely need to change are: The update is now complete. If such acts allow unauthorized access to your software or other copyrighted work, you may have a right to sue for relief under that Act. The two pin connections have parallel functionality; for exam- ple, pins 1, 3, 5 and 7 have SPI1 functionality on the top pin segment, with similar SPI2 functionality on the corresponding pins in the middle pin segment.
Apply power to the Explorer 16 board.